Interface Personalisation; Lock/Unlock; External Controls Management - voestalpine Böhler URANOS 2200 TLH Instrucciones De Uso

Select the required parameter by rotating the encoder
until it is displayed within the central quadrant (5).
Store the selected parameter in the 7 segment display
by pressing button (2)
Save and exit the current screen by pressing button (4)
.
Default I1

3.7 Interface personalisation

Allows the parameters to be customized on the main menu.
500 Allows the selection of the required graphic interface:
XE (Easy Mode)
XA (Advanced Mode)
XP (Professional Mode)
PROCESS PARAMETER
MMA
XE
TIG DC
MMA
XA
TIG DC
MMA
XP
TIG DC

3.8 Lock/unlock

Allows all the settings to be locked from the control panel with
a security password.
Enter set-up by pressing the encoder key for at least 5 seconds.
Select the required parameter (551) by rotating the encoder
until it is displayed within the central quadrant.
Activate the regulation of the selected parameter by pressing the
encoder button.
Set a numerical code (password) by rotating the encoder.
Confirm the change made by pressing the encoder button.
.
Save and exit the current screen by pressing button (4)
The carrying out of any operation on a locked control panel
causes a special screen to appear.
- Access the panel functionalities temporarily (5 minutes) by
rotating the encoder and entering the correct password.
Confirm the change made by pressing encoder button.
- Unlock the control panel definitively by entering set-up (fol-
low the instructions given above) and bring back parameter
551 to "off".
Confirm the changes made by pressing button (4)

3.9 External controls management

Allows the setting of the welding parameters management
method by the external devices (RC, torch...).
Enter set-up by pressing the encoder key for at least 5 seconds.
Select the required parameter (602) by rotating the encoder
until it is displayed within the central quadrant.
.
.
37