HAMPTON BAY 52-NORD Guía De Uso Y Mantenimiento página 7

Assembly - Standard Ceiling Mount
1
Preparing for standard mounting
□
Remove the canopy ring (JJ) from the canopy (C) by turning the
ring counter-clockwise until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (HH) located in the "L
shaped" slots.
□
Remove and save the two canopy screws (II) in the round holes.
This will enable you to remove the mounting bracket (A).
HH
3
Assembling the fan
WARNING: Failure to properly install the locking pin (DD) could
result in the fan becoming loose and possibly falling.
□
Loosen, but do not remove, the setscrews (KK) on the collar
on top of the fan-motor assembly (E).
□
Align the holes at the bottom of the ball/downrod assembly
(B) with the holes in the collar on top of the fan-motor
assembly (E).
□
Carefully insert the hanger pin (CC) through the holes in
the collar and ball/downrod assembly (B). Be careful not to
jam the hanger pin (CC) against the wiring inside the ball/
downrod assembly (B).
□
Insert the locking pin (DD) through the hole near the end of
the hanger pin (CC) until it snaps into its locked position.
□
Re-tighten the setscrews (KK) on the collar on top of the
fan-motor assembly (E).
2
Routing the wires
□
Route the wires exiting the top of the fan motor
assembly (E) through the center of the canopy ring (JJ).
Make sure the slots on the canopy ring (JJ) are on top.
□
Insert the ball/downrod (B) through the canopy (C) and
slide the decorative motor collar cover (D) onto the end
of the ball/downrod (B). Make sure the slots on the
canopy (C) are on top.
□
Route the wires exiting the top of the fan motor
assembly (E) through the downrod (B) as shown.
A
II
C
JJ
CC
7
Please contact 1-855-HD-HAMPTON for further assistance.
C
JJ
D
B
E
C
JJ
D
B
DD
KK
E
HAMPTONBAY.COM