Husqvarna ST 224 Manual De Usuario página 13

9. If the choke was used to start the engine, release the
electric start button and slowly move the choke (D)
to the OFF position.
D
B
E
A
C
F
10. Disconnect the extension cord from the receptacle
first and then from the engine.
11. Run the engine 2-3 minutes at idling speed before
you start to throw snow.
To operate the product
CAUTION: Do not operate without snow or
water to lubricate the auger blades. Incorrect
use can cause high temperatures in the
auger blades, especially if the product is
new. This can cause damage to the auger
blades and scraper bar.
CAUTION: Do not partially engage drive or
auger levers for an extended period of time;
this can lead to premature wear or burning
of the belts.
Note: When both the drive engagement and auger
engagement are engaged, the drive engagement will
lock the auger engagement in position. Use the right
hand to control the snow discharge chute.
Note: Do not change the speed when the drive lever is
engaged. This can cause damage to the transmission.
673 - 003 - 08.01.2020
1. To engage the auger blades, push the auger
H
2. Raise the drive speed control lever (B) from the
G
3. Lower the drive speed control lever from the middle
4. To make the product move in the selected direction,
engagement (A) to the handle to engage the auger
and throw snow.
middle position to make the product move forward
when the drive engagement (C) is engaged. Do not
change the speed when the drive lever is engaged.
This can cause damage to the transmission.
position to make the product move rearward when
the drive engagement is engaged.
C
hold the drive engagement (C) against the handle .
A
B
13