Supplied Components; Preparing The Remote Control Unit And The Touch Pen - Sharp PN-L705H Manual De Instalación

If any components are missing, please contact your dealer.
 Liquid Crystal Display Monitor: 1
 Remote control unit: 1
 Cable clamp (insertion type): 4
 Cable clamp: 3
 Power cord: 1
 Remote control unit battery
(R-03 ("AAA" size)): 2
* SHARP Corporation holds authorship rights to the Utility Disk program. Do not reproduce it without permission.
* For environmental protection!
Do not dispose of batteries in household waste. Follow the disposal instructions for your area.

Preparing the Remote Control Unit and the Touch Pen

Installing the batteries
1. Place your finger on the part marked with the ▲, and
then pull the cover off.
2. See the instructions in the compartment and put in the
supplied batteries (R-03 ("AAA" size) x 2) with their
plus (+) and minus (-) sides oriented correctly.
3. Close the cover.
Connecting the touch pen adapter
To use the touch pen, insert the touch pen adapter into the
touch pen adapter port on the monitor.
Touch pen
adapter port
Touch pen
adaptor

Supplied Components

 CD-ROM (Utility Disk): 1
 SHARP Display Connect License: 1
 Setup Manual (this manual): 1
 Touch pen (for capacitive touch panel): 1
 Touch pen adapter: 1
 Pen tip for touch pen
(for capacitive touch panel): 2
 Touch pen battery
(LR-03 ("AAA" size)): 1
 Tray: 1
 Speaker cover: 2
 USB cable: 1
 USB extension cable: 1
Inserting the battery
1. Remove the battery cap and main cover.
2. Open the battery cover and insert the supplied battery
(LR-03 ("AAA" size) x 1) into the touch pen.
Check the plus (+) and minus (-) markings on the inside
of the touch pen and insert the battery in the correct
orientation.
3. Replace the battery cover and main cover.
While pressing the battery cover, replace the main cover.
4. Replace the battery cap.
Touch pen
adapter screw
(antitheft)
TIPS
• To use an optional touch pen with the monitor, the touch
pen must be registered in the touch pen adapter. (pairing)
For details, see the Touch pen Management Tool operation
manual.
 RS-232C conversion cable (3.5mm mini jack): 1
 Eraser (for capacitive touch panel): 1
 Camera mount: 1
 Camera screw (inch thread): 1
 Speaker cover attachment screws (M3)/
Camera mount screws (M3): 6
 Touch pen adapter screw (Step screw, M3): 1
 Vertical sticker (Logo): 1
 Cover SHARP logo: 1
Place this sticker onto the SHARP logo to cover
the logo.
2
Main cover Battery cap
Battery cover
1
2
1
1
2
5
E