Supplied Components; Adjustment Of Monitor Position - Sharp PN-K322B Manual De Instalación

If any component should be missing, please contact your dealer.
 Liquid Crystal Display Monitor: 1  Touch pen: 1  Cable cover: 1  Power cord: 1  AC adapter: 1
 CD-ROM (Utility Disk for Windows): 1  Setup Manual (this manual): 1  DisplayPort cable: 1
 RS-232C conversion cable (Φ3.5 mini-jack): 1  USB cable (for touch panel, miniB): 1  Cable clamp: 2
 Cable clamp (small): 1  Cable clamp (large): 3  Anti-toppling clamp: 2  Screws (for anti-toppling) (M4 x 10): 2
 Vertical sticker (Logo): 1  Vertical sticker (Operation buttons): 1  Vertical sticker (Blank): 1
 Horizontal sticker (Operation buttons): 1  Cover Sharp logo: 1 (Place this sticker onto the SHARP logo to cover the logo.)
* Sharp Corporation holds authorship rights to the Utility Disk program. Do not reproduce it without permission.

Adjustment of monitor position

You can slide the monitor to adjust its position.
Use the monitor in the perpendicular position (about 90° from horizontal, Fig. A below) or slid to the bottommost position (about
25° from horizontal, Fig. B below). If used in any other position, the monitor may slide while in use.
A
B
When moving the monitor from the position of Fig. B to the position of Fig. A above, slightly lift the monitor (1) and slide toward
the back (2).
Caution
• When sliding the monitor, be sure to grasp only the frame on the left and right sides.
- Take care not to pinch your fingers.
- Grasping and applying pressure to the LCD panel may damage it.
- Take care not to press any buttons. This may cause the volume or other settings to change.

Supplied Components

(2)
(1)
A
B
25°
5
E