Electrical Connection - Dometic CS 110 Manual Del Usuario

1. Remove the transport pallet on which your
wine cellar rests.
2. Adjust the feet to allow a 30 mm clear-
ance under the wine cellar and verify
that it stands in a vertical position in both
directions. If necessary, use a spirit level.
3. Attach the distance bar using the two
screws at the top back on each side of the
cellar. The bar ensures the correct distance
to the wall behind.
. For optimum performance, please place
your wine cellar far away from any source
of heat, e.g. radiator, cooker or intense
sunlight.
5. Check that the charcoal filter is in place at
the top left corner inside the wine cellar.
6. Fit the door handle to the door, see "Ap-
pendix B".
EN
7. Attach the drip tray on the back. The
screws are already attached at the back.

ElEctrical connEction

The electrical installation must be carried out cor-
rectly, taking into account all relevant regulations
and codes of practice. The wine cellar operates on
a mono-phased alternating current.
Please check that the voltage shown on the data
plate corresponds to your power supply.
!
the wine cellar must be earthed.
The wine cellar is fitted with a plug intended for an
earthed socket. Dometic and its subsidiaries will
not be held responsible for any incident due to non-
existent or defective earth wires.
Electrical leads must be routed and secured so
that they cannot come into contact with hot or
sharp parts of the wine cellar.
- 8 -
WARNING