Electrical Safety; Safety Instructions - Atlantic MD250 Manual De Operación

• CAUTION:
THIS PUMP IS TO BE USED IN A CIRCUIT PROTECTED BY A GROUND CIRCUIT INTERRUPTER.
• CAUTION:
THIS PUMP HAS BEEN EVALUATED FOR USE IN WATER ONLY.
• WARNING:
RISK OF ELECTRIC SHOCK - THIS PUMP IS SUPPLIED WITH A GROUNDING CONDUCTOR AND
GROUNDING-TYPE ATTACHMENT PLUG. TO REDUCE THE RISK OF ELECTRIC SHOCK, BE CERTAIN
THAT IT IS CONNECTED ONLY TO A PROPERLY GROUNDED, GROUNDING TYPE RECEPTACLE.

Electrical Safety

• Electrical wiring should be installed by a qualified electrician in accordance with all
applicable safety regulations. Incorrect wiring can lead to a pump malfunction, electrical
shock or fire.
• Pumps should operate on a designated, 110/120 volt circuit.
• Pump must be protected by a ground fault circuit interrupter (GFCI).
• Pump must be plugged into a standard, properly grounded, three pronged outlet.

Safety Instructions

ATTENTION
Fig. 1
• Do not lift, lower or handle the pump by pulling on the electrical cord. Make sure the
electrical cable does not become excessively bent or twisted and does not rub against a
structure in a way that might damage it. (Fig. 1)
• Always disconnect the power supply before doing any maintenance or placing your hands
into the water to which this pump is immersed. (Fig. 2)
• The submersible pump should not be used if the electrical supply cable is damaged in
any way. If a cable with damaged insulation is submerged in water, there is danger of
water seeping into the pump motor and causing a short. The electrical cable cannot be
replaced. If the cord is damaged, the pump should be discarded. Altering the electrical
cable in any way will void the warranty. (Fig. 3)
Operation
• Mag Drive Series pumps are for use in water only. Water temperature should never
exceed 95˚ F (35˚ C).
Make sure the pump works at a proper water level. Do not
operate the pump without water. If so, the pump should be
turned off immediately and check.
Fig. 2 Fig. 3
3