Power-Cord Caution - PIONEER DJ CDJ-2000NXS2 Manual De Instrucciones

When using this product, confirm the safety
information shown on the bottom of the unit.
WARNING
Store small parts out of the reach of children and
infants. If accidentally swallowed, contact a doctor
immediately.
This product satisfies electromagnetic noise
regulations when it is connected to other equipment
through shielded cables and connectors.
Use only the furnished accessory connecting cables.

POWER-CORD CAUTION

Handle the power cord by the plug. Do not pull out the
plug by tugging the cord and never touch the power
cord when your hands are wet as this could cause a
short circuit or electric shock. Do not place the unit, a
piece of furniture, etc., on the power cord, or pinch the
cord. Never make a knot in the cord or tie it with other
cords. The power cords should be routed such that they
are not likely to be stepped on. A damaged power cord
can cause a fire or give you an electrical shock. Check
the power cord once in a while. When you find it
damaged, ask your nearest service center or your
dealer for a replacement.
CAUTION
This product is a class 1 laser product classified
under the Safety of laser products, IEC 60825-1:2007.
D3-4-2-2-4_B1_En
D41-6-4_A1_En
Condensation
Water droplets (condensation) may form inside the unit
(on operating parts and lenses) in the winter, for
example, if the unit is moved from a cold place into a
warm room or if the temperature in the room in which
D44-8-2_A1_En
the unit is installed rises suddenly (through heating,
etc.). The unit will not operate properly and will not be
playable with condensation inside. Let the unit stand for
1 to 2 hours at room temperature (though this time
depends on the conditions of the condensation) without
turning on the power. The water droplets will evaporate
and the unit will become playable. Condensation can
occur in the summer as well if the unit is exposed to the
direct wind from an air-conditioner, etc. If this happens,
move the unit to a different location.
S002*_A1_En
CLASS 1 LASER PRODUCT
D58-5-2-2a_A1_En
S005b_A1_En
3
En