Napa 520-1007 Instrucciones De Operación página 3

INSPECTION
Visual inspection should be made before each use
of the jack, checking for leaking hydraulic fluid and
damaged, loose or missing parts. Each jack must
be inspected by a manufacturer's repair facility
immediately, if subjected to an abnormal load or
shock. Any jack which appears to be damaged in
any way, found to be badly worn, or operates
abnormally MUST BE REMOVED FROM SERVICE until
necessary repairs are made by a manufacturer's
authorized repair
that an annual inspection of the jack be made by a
manufacturer's authorized repair facility and that any
defective parts, decals or warning labels be replaced
with manufacturer's specified parts.
A list of authorized repair facilities is available from the
manufacturer.
LUBRICATION
All moving joints require lubrication often. Remove
handle and grease the lower end of handle where it
rotates in the handle socket. Grease release valve gears.
Using a grease gun, grease the lift arm pivot shaft grease
fitting until grease appears at the end of the shaft. Oil
all lift arm linkages, front wheels and rear casters.
OWNER/USER RESPONSIBILITY
The owner and/or user must have a thorough
understanding of the
instructions and warnings before using this jack. Personnel
involved in the use and operation of equipment shall be
careful, competent, trained, and qualified in the safe
operation of the equipment and its proper use when
servicing motor vehicles and their components. Warning
information should be emphasized and understood. If
the operator is not fluent in English, the manufacturer's
instructions and warning shall be read to and discussed
with the operator in the operator's native language by
the purchaser/ owner, making sure that the operator
comprehends its contents.
Owner and/or user must study and maintain for future
reference the manufacturer's instructions. Owner and/or
user is responsible for keeping all warning labels and
instruction manuals legible and intact. Replacement labels
and literature are available from the manufacturer.
REV. 04/28/05
facility. It is recommended
manufacturer's operating
MAINTENANCE
IMPORTANT: When adding or replacing oil, always
use a quality hydraulic oil. DO NOT use brake fluid,
transmission fluid, alcohol, glycerine, detergent motor
oil, or dirty oil as improper fluid can cause serious
internal damage to jack.
To add oil: With saddle fully lowered and jack on
level ground, remove filler plug (see Fig. 1). Oil
should be filled to level of oil filler plug hole. If low,
add oil as needed.
Maintenance and Inspection: The owner and/or user
must maintain and inspect the jack in accordance with
the manufacturer's instructions.
SPECIFICATIONS
Low Height . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-1/8"
High Height . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19-5/16"
Saddle Diameter . . . . . . . . . . . . . . . . . . . . . . . . . . 5-1/8"
Handle Length. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40"
Base Length . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25"
Chassis Width . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14"
3
Fig. 1