Changing The Oil; Cleaning And Maintenance - Princess 182648 Instrucciones De Uso

CHANGING THE OIL

Make sure the fryer and the oil or fat have cooled down before changing the oil or fat (remove the plug
from the socket). Change the oil regularly. This is particularly necessary when the oil or fat goes dark or
the smell changes. Always change the oil after every 10 frying sessions. Change the oil in one go – never
mix old and new oil. Used oil is harmful to the environment. Do not dispose of it with your normal rubbish
but follow the guidelines issued by the local authorities.

CLEANING AND MAINTENANCE

NEVER IMMERSE THE APPLIANCE IN WATER! REMOVE THE PLUG FROM THE SOCKET.
- Clean both inside and outside the fryer regularly.
- Regularly clean the outside of the fryer with a damp cloth and dry it with a soft, clean towel.
- Do not use abrasive detergents.
- The basket and the handle can be cleaned in warm soapy water. Dry thoroughly before reusing.
- When replacing the oil, you can also clean the inside of the fryer. Empty the fryer and first clean the
inside with a paper towel and then wipe with a wet cloth dipped in soapy water. Then wipe the inside
with a damp cloth and allow it to dry.
CHANGING THE ANTI-ODOUR FILTER
Your fryer comes complete with an anti-odour filter in the lid. This should be replaced after approximately
80 hours of use.
PRINCESS TIPS
- Always place the fryer on a stable surface and keep flammable materials away.
- Do not place the fryer on or near a switched-on hot plate.
- Before you use the fryer it must be filled with the required amount of fat or oil. Never use the fryer
without oil or fat as this will damage the appliance.
- Never fryer the appliance during use. The oil becomes hot and you can burn yourself. Wait until the oil
has cooled down before moving the fryer.
- This fryer is protected by thermal protection. This means it switches itself off when it overheats.
- Never immerse the appliance in water!
- Do not leave the appliance unattended while in use. Close supervision is necessary when the fryer is
used near children.
- If the fryer or the cord are damaged they should be repaired by a reputable service company. Never
attempt to carry out your own repairs or to replace the cord. Special equipment is needed for this.
- Children should be supervised to ensure that they do not play with the appliance.
- The use of this appliance by children or persons with a physical, sensory, mental or motorial disability,
or lack of experience and knowledge can give cause to hazards. Persons responsible for their safety
should give explicit instructions or supervise the use of the appliance.
- The appliance is not intended to be operated by means of an external timer or separate remote-control
system.
U.K. WIRING INSTRUCTIONS
The wires in the mains lead are coloured in accordance with the following code:
BLUE = neutral, BROWN = LIVE, GREEN-YELLOW = EARTH
As the colours of the wire in the mains lead of this appliance may not correspond with the colour
markings identifying the terminals on your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter
N or coloured black.
The wire which is coloured BROWN must be connected to the terminal which is marked
with the letter L or coloured red.
The wire which is coloured GREEN-YELLOW must be connected to the earth terminal
which is marked with the letter E or
With this appliance, if a 13 amp plug is used a 13 amp fuse should be fitted. If any other
type of plug is used a 15 amp fuse must be fitted either in the plug or at the distribution board.
WARNING: THIS APPLIANCE MUST BE EARTHED
or coloured green and yellow.
8