Publicidad
Step 7
Fasten four TIE PLATES (3G) to the VALANCE (M59). Use four
å
BLACK 9/16" LARGE HEAD SCREWS (1S).
Fasten the VALANCE (M59) to the TOP MOLDING (M12). Use two
å
BLACK 9/16" LARGE HEAD SCREWS (1S) through the TIE PLATES
and into the TOP MOLDING.
Fasten the END MOLDINGS (M71) to the ENDS (A and B) and
å
VALANCE (M59). Use ten BLACK 9/16" LARGE HEAD SCREWS (1S)
through the TIE PLATES and ANGLE BRACKETS and into the
END MOLDINGS.
NOTE: There are no pre-drilled holes in the END MOLDINGS. The
å
SCREWS will tighten into the grooves.
Fasten the SHELF MOLDING (M38) (with the LARGE RUBBER
å
SLEEVES) to the ENDS (A and B). Use two BLACK 9/16" LARGE
HEAD SCREWS (1S) through the ANGLE BRACKETS and into the
SHELF MOLDING.
M12
Page 12
M59
M71
M71
B
A
M38
D
401632
BLACK 9/16" LARGE HEAD SCREW
(18 used in this step
M59
3G
The LARGE RUBBER
SLEEVES should be here.
www.sauder.com/services
1S
3G
Publicidad
