Craftmade CT52 Instrucciones De Instalación página 4

6
Insert wires, including steel cable,
hole "A" in bottom of "support arm distributor" (#8). Insert ends of remaining
two rods into holes "B" and "C" in bottom of distributor. Place wires through
hex nut and tighten nut securely onto support rod. Use hex nuts to secure
remaining two rods into place. Insert wires through hole "D" and pull
through top of downrod section of distributor.
Side View of Support Arm
Distributor Assembly (#8)
D
A
Support Rod (#7)
Hex Nut
CAUTION:
Do not mount fan to sheet rock or
drywall type materials. To insure proper
support use the two #1 wood screws
to secure mounting bracket to joist or
beam, if the location you have chosen
does not have a suitable support beam,
install a 2" x 4" brace between ceiling
joists to support fan, or one of the
many NEC and UL approved ceiling
fan braces.
WARNING:
To reduce the risk of fire, electric shock or personal injury, mount to outlet box
marked "acceptable for fan support" and use mounting screws provided with the
outlet box. Most outlet boxes commonly used for the support of lighting fixtures
are not acceptable for fan support and may need to be replaced. Consult a qualified
electrician if in doubt.
All manuals and user guides at all-guides.com
Step 6
from top of support rod (#7) through
Downrod Section
B
Wiring Harness
(including steel wire)
A
C
B
Top View of Support
Arm Distributor (#8)
7
Step 7
Locate downrod assembly (#2).
Loosen ball screw on black hanging
ball to free lock pin. Black hanging
ball will slide down. Remove ground
screw and green ground wire.
Remove hanging ball from downrod
and save all parts. Insert wires and
steel cable from distributor assembly
through downrod. Screw downrod
into top of Support Arm Distributor
Assembly (#8), being careful that
wires are pulled through.
8
Position downrod so the hole in the downrod aligns with the hole in the
distributor assembly. Insert safety bolt (S10) through distributor assembly
and downrod and attach nut. Tighten firmly. Tighten set screw "A" against
downrod. Place distributor cover (#8a) over support arm distributor (#8).
Next place canopy (#3) over downrod assembly (#2). Replace hanging ball,
insert hanging pin through downrod and tighten set screw "C" in hanging
ball into downrod.
Threaded
Set Screw Hole
Ground
Hanging
Wire
Pin
Ball
Hanging
Screw
Ball
Safety Bolt
and Nut
WARNING:
Failure to completely tighten downrod as described in steps 7 & 8 above could
result in the fan loosening and possibly falling.
Lock Pin
Green Ground
Wire
Ball Screw
Downrod
Assembly
Hanging Ball
(#2)
Downrod
Support Arm
Distributor
Assembly (#8)
Step 8
Set Screw (C)
Downrod (2)
Canopy (3)
Distributor
Cover (8a)
Set Screw (A)
Distributor
Assembly (2)