Thermador CVS2 Manual Del Usuario página 6

8"
2 1/4"
Dimensions are dependent on
discharge direction.
Integral/Remote
9-13/16"
A
13"
B
F. Investigate potential ductwork routes
and choose the shortest possible route
from the unit to an outside wall or to the
roof via an inside wall and attic. For
duidance, typical ducting installations are
shown in figures 3 through 6. Installation
in island locations will require under floor
ducting. Peninsula locations usually
require ducting laterally through cabinets
or under cabinet toespaces. Consider
potential interferences to ductwork from
building framing (floor joists, wall studs,
etc.) and utilities (electrical wiring, water,
gas, or sewer lines, etc).
6
Cooktop
5 1/2"
6 1/2"
22"
14"
G. Determine whether the chosen route of
H. Purchase the necessary ductwork in
Be certain to avoid interference with gas and
electric supply to cooktop.
Shelving and drawer depths are dependent
upon cooktop depth and setback.
Cutout
Depth
Cooktop
Drawer
Shelving must
be removable
ducting will meet vent system
performance requirements. To do this,
measure the duct lengths needed and
determine specific fittings required. Enter
this data in the spaces provided in
addition, the duct installation guidelines
in Table 2 (See Page 9) should be
followed in developing the ductwork
plan.
accordance with the listing developed in
G above.
SB (see
Fig. 7,8)
Fig. 2