Declaration Of Conformity - Beta 1932B13 Manual De Uso E Instrucciones

USE
Start / Stop
To start the pneumatic tool, press the trigger (picture 4), and keep it pressed during the job to be performed. Releasing the trigger will
cause the pneumatic tool to stop almost immediately.
Check the position of the reverse lever before operating the pneumatic tool, so as to know the direction of rotation.
Direction of rotation setting
The pneumatic tool can rotate both clockwise and anticlockwise. Use the reverse lever to select the direction of rotation (picture 4):
" F " FORWARD
" R " REVERSE
Chuck
Self-locking chuck: the chuck capacity is such as to support drill bits 1.5 ÷ 13 mm in diameter (picture 5).
Fit in the drill bit as follows:
• Manually lock the rear nut of the chuck;
• Manually rotate the front nut anticlockwise, open the chuck until the drill bit fits in;
• Fit in the required drill bit;
• Manually rotate the front nut clockwise, until it clicks. The chuck is thus automatically locked.
Replace the drill bit as follows:
• Manually lock the rear nut of the chuck;
• Manually rotate the front nut anticlockwise, to release the drill bit from the chuck;
• Fit in the drill bit, if need be, and follow the above instructions.
Always disconnect air supply before fitting in cutting tools or making adjustments; this precaution will prevent the pneumatic tool from
being accidentally started.
Lubrication
The pneumatic tool must be connected to a filter-lubricator unit (we recommend item 1919F1/4) provided with an air-oil microfog mixer,
set at two drops per minute. This will result in a high-performing tool and wear-resistant mechanical parts.
If lubrication is not provided to the line, oil ISO 32 must be periodically poured into the pneumatic tool, through the air supply hole
(picture 6).
MAINTENANCE
Maintenance and repair jobs must be carried out by trained personnel. For such jobs, you can contact Beta Utensili S.P.A.'s repair
centre.
DISPOSAL
The pneumatic tool, accessories and packaging should be sent to a waste disposal centre, in accordance with the laws in force in your
country.
WARRANTY
This tool is manufactured and tested in accordance with current EU regulations, and is covered by a 12-month warranty for professional
use or a 24-month warranty for nonprofessional use.
We will repair any breakdowns caused by material or manufacturing defects by fixing the defective pieces or replacing them at our
discretion.
Should assistance be required once or several times during the warranty period, the expiry date of this warranty will remain unchanged.
This warranty will not cover defects due to wear, misuse or breakdowns caused by blows and/or falls. In addition, this warranty will no
longer be valid if any changes are made, or if the pneumatic tool is forced or sent to the customer service in pieces.
This warranty explicitly excludes any damage to people and/or things, whether direct or consequential.
We hereby declare, assuming full responsibility, that the described product complies with all the relevant provisions of Machine
Directive 2006/42/EC and amendments thereto, as well as with the following standard:
• EN ISO 11148-3
The Technical Brochure is available at:
BETA UTENSILI S.P.A.
Via A. Volta 18 - 20845 Sovico (MB) - ITALY
Name and title of person in charge
MASSIMO CICERI
(Managing Director)
BETA UTENSILI S.P.A.
Via A. Volta 18
20845 Sovico (MB)
ITALY
clockwise - seen from the operator's side
anticlockwise - seen from the operator's side

DECLARATION OF CONFORMITY

Date 01/01/2015