Maintenance Maintenance And Inspection - Hitachi NV 45AB2 Instrucciones Y Manual De Seguridad

Ocultar thumbs Ver también para NV 45AB2:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
NOTE:
The information contained in this Manual is designed to assist you in the safe maintenance of
the Nailer.
Some illustrations in this Manual may show details or attachments that differ from those on
your own Nailer.
MAINTENANCE AND INSPECTION
Read section titled "SAFETY" (pages 4 – 7).
WARNING
Disconnect air hose and remove all nails from
Nailer when:
1) doing maintenance and inspection; and
2) clearing a jam.
Never use gasoline or other highly flammable
liquides for cleaning.
1. Clearing a jam
Remove a jammed nail in the following order :
1 DISCONNECT AIR HOSE.
2 Open the nail guide.
3 Insert a rod into the outlet.
Tap the rod with a hammer.
4 Remove the jammed nail with a slotted screw
driver.
Nail
5 Cut the deformed collated wire with nippers.
Correct the deformation.
6 In case of frequent jam, contact a Hitachi authorized
service center.
MAINTENANCE
Hammer
Rod
Outlet
1
Disconnect
air hose
Slotted Screw Driver
2. Inspecting the feeders
1 DISCONNECT AIR HOSE.
2 Clean the knob sliding part.
Lubricate it with Hitachi pneumatic tool lubricant.
Nail Guide
3 Open the nail guide and remove dust.
Lubricate the nose opening and feeder shaft.
CAUTION
Check that the main nail stopper and sub nail stopper
slide smoothly by pushing them with finger.
If not smooth, nails can be driven at an irregular angle
and hurt someone.
Main Nail Stopper
Nail Guide
Sub Nail Stopper
4 Lubricate the feeding surfaces of the nose and the
nail guide after cleaning.
This promotes smooth operation and prevents rust.
— 16 —
Knob
1
Disconnect
air hose
Nose Opening
Feeder Shaft
Feeder

Publicidad

Tabla de contenido
loading

Tabla de contenido