Technical Data - Toolson PRO-AS 18 Manual De Instrucciones

Anleitung PRO_AS_18_SPK7:_
GB
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety regulations
The corresponding safety information can be found
in the enclosed booklet.
2. Layout and items supplied (Fig. 1)
1. Torque selector
2. Battery capacity indicator
3. Changeover switch
4. ON/OFF switch
5. Battery pack
6. Battery charger
7. Selector switch for 1st/2nd gear
8. Pushlock button
9. Quick-change drill chuck
10. LED lamp
11. ON/OFF switch LED lamp
12. Magnetic screw holder
13. Cover
14. Bit magazine
15. Metal and voltage detector
3. Proper use
The cordless drill/screwdriver is designed for
tightening and undoing screws, as well as for drilling
in wood, metal and plastic.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
12
01.08.2007 10:10 Uhr Seite 12

4. Technical data

Voltage supply
Speed 0-350 / 0-1100 rpm
Torque
Forward and reverse rotation
Chuck clamping width
Battery charging voltage
Battery charging current
Mains voltage for charger 230 V ~ 50 Hz
Sound pressure level L
pA
Sound power level L
WA
Vibration a
hv
Weight
5. Before starting the equipment
Be sure to read the following information before you
use your cordless screwdriver for the first time:
1. Charge the battery pack with the charger
supplied. An empty battery pack requires a
charging period of approximately 1 hour.
2. Only ever use sharp drill bits and screwdriver bits
which are suitable for the purpose and in
faultless condition.
3. Always check for concealed electric cables and
gas and water pipes when drilling and screwing
in walls.
6. Operation
6.1 Charging the NC battery pack (Fig. 2/3)
1. Remove the battery pack (5) from the handle,
pressing the pushlock buttons (8) downwards to
do so.
2. Check that your mains voltage is the same as
that marked on the rating plate of the battery
charger. Plug the mains plug of the charger (6)
into the mains socket outlet.
3. The green LED on the charger will come on.
Push the battery pack (5) onto the battery
charger (6). Now the rot LED will come on to
indicate that the battery pack is being charged.
When the charging period is completed after
approx. 1 hour, the green LED on the charger
will come on again. The temperature of the
battery (5) may rise during the charging
operation. This is normal.
18 V d.c.
23 levels
yes
1 - 10 mm
18 V d.c.
2,5 A
75 dB
89 dB
≤ 2,5 m/s 2
1.9 kg