Planika Scandi Manual De Usuario Y De Montaje página 10

1. If the fuel container is empty (
holder ( ) (I).
2. Insert a full fuel container with a cap removed (
3. Screw the cap with the pumping hose back on (III).
The green diode indicates that the device is ready to ignite the flame.
Press and hold START for 3 seconds. Flame ignition will take 2-10 minutes (
can be present during the ignition. The diode READY off (
and the device reached the working temperature.
After 3 min, press ECO to lower the flame (two sound signals). Press ECO again to increase the flame height (one
sound signal).
ATTENTION! In case the device temperature is too high, the flame will be automatically lowered (ECO) and the height
regulation blocked. If the temperature keeps increasing, the device will be turned off.
Press STOP to extinguish the flame (sound signal +
You can ignite the flame again when the device is cooled – the green diode READY (
The FAST START offers faster flame ignition (when the device is ready (
The function is enabled by default.
To disable FAST START, press and hold ECO for 10 seconds (four sound signals). To enable the function, press
and hold ECO for 10 seconds (two sound signals).
REPLACING FUEL CONTAINER
), unscrew the cap with the pumping hose and remove the container from the
) (II).
I
FLAME IGNITION
FLAME HEIGHT REGULATION
FLAME EXTINGUISHING
).
FAST START
10
II
). The smell of ethanol vapours
) indicates that
the flame has been ignited
), the power consumption is 60 W higher).
READY
III
).