THERMEx MINI PERPIGNAN Instrucciones De Montaje página 48

48
THERMEX MINI PERPIGNAN & MINI BORDEAUX
7
Mark the position of the two lock-holes on the
wall and then remove the hood from the wall
once again.
10
Screw the screws into the two lock-holes.
INSTALLING THE DUCT FOR OPEN-AIR VENTING
If the hood is going to be installed with exhaust venting into the open air, the duct is installed as follows:
1
x2
Measure the placement of the bracket and
mark the position of the holes on the wall.
NOTE: The bracket must be positioned so that
it matches the holes in the duct.
8
x2
Pre-drill the holes and insert the rawlplugs.
11
x2
Reinstal the filter in the hood and close the
glass door.
2
Pre-drill the holes and insert the rawlplugs.
x2
x2
x2
M 540231181226012016
9
Re-hang the hood.
NOTE: For a rear-facing exhaust outlet, the
exhaust outlet should be installed on the hood
in this step.
12
Install the exhaust outlet on the hood.
NOTE: This only applies when venting into
open air and with the exhaust outlet facing
upwards.
3
Screw the bracket onto the wall.