Explore Scientific NDC1004 Manual De Instrucciones página 9

5. Press [SET] button several times until you
exit the setting mode.
°C/°F SETTING
1. Press [DOWN] button to switch Celsius (°C)
/ Fahrenheit (°F).
ALARM
SETTING/ADJUSTING ALARM TIME
1. Press and hold [AL.SET] button to enter the
alarm setting mode.
3. The setting parameter will flash.
4. Press [UP] or [DOWN] button to set the de-
sired data.
5. Press [AL.SET] button to confirm setting
and enter to next parameter.
6. Sequence of setting: Hour  Minute  Exit
8. If there is no action in 20 seconds, the setting
will be saved and will exit the setting mode.
TURN ON/OFF ALARM
1. In standard mode, press the [UP] button to
turn on/off the alarm.
2. The alarm lasts 2 minutes and becomes
faster and faster over time.
OPERATION
1. At the set time, alarm signal rings.
2. During the alarm, press the touch button to
delay the alarm by 5 minutes.
3. If you do not press any button to stop the
alarm, it will automatically turn off after 2
minutes.
4. To stop the alarm, press [AL.SET] or any
other button.
5. The alarm will start again at the next alarm
time, unless you switch off the alarm func-
tion by pressing the [UP] button.
EN
IT
DE
FR
ES
9