Getting Started - Explore Scientific NDC1004 Manual De Instrucciones

GETTING STARTED

INSERT BATTERIES
1. Remove the battery door from the back.
2. Insert 3x AAA (LR03)/1.5V batteries. Please
ensure the polarities (+/-) of the batteries
match upon installation.
3. Reattach the battery door.
NOTE: Replace batteries when [
or when the display is dim.
CLOCK
SET THE CLOCK MANUALLY
1. Press and hold [SET] button to enter time
and date setting.
2. The setting parameter will flash.
3. Press [UP] button once, the figure will in-
crease 1 unit (when setting minute, second
8
will reset to 0). Press and hold the [UP] but-
ton, the figures will increase rapidly.
4. Press [DOWN] button once, the figure will de-
crease 1 unit (when setting minute, second
will reset to 0). Press and hold the [DOWN]
button, the figures will decrease rapidly.
5. Press [SET] button to confirm setting and
enter to next parameter.
6. Sequence of setting: Time Zone +/-12h 
] displays, Time format 12/24h  Hour  Minute 
Year  Month  Date  Exit
7. If there is no action in 30 seconds, the setting
will be saved and will exit the setting mode.
TIME ZONE SETTING
To set a different time zone, proceed as follows:
1. Press and hold [SET] button to enter time
and date setting.
2. Press [+] or [–] button to set the time zone
offset +/-12 hours.