Decoder Installation; Disposal; Warranty - marklin 59083 Manual Del Usuario

Decoder Installation

See the section "CV Programming" for changes to other char-
acteristics in the fx (MM) protocol using CV programming or to
the DCC CV programming.
The following work steps may only be done in a voltage-free
work environment:
Note: Settings with the DIP switches are to be only when the
voltage is turned off. The digital installation decoder does not
recognize the current switch settings until the voltage is turned
on.
See page 23 for installation of the digital installation decoder
in Märklin standard turnouts, curved turnouts, or double slip
switches.
Starting on page 29 you'll find the table for setting addresses
with DIP switches.

Disposal

Information about protecting the environment:
Products marked with a trashcan with a line
through it may not be disposed of at the end of
their useful life along with the normal household
trash. They must be taken to a collection point for
recycling electrical and electronic devices. The
symbol on the product, the instructions, or the
packaging indicates this. Depending on their description, the
raw materials can be used again. You make an important
contribution to the protection of our environment with the
recycling of this material from old devices. Please inquire in
your community about the appropriate disposal site.

Warranty

The warranty terms are stated on the warranty card included
with this product.
• U.S. only:
Please see your authorized Märklin specialty dealer for
service and repairs or contact the USA subsidiary using the
contact form at www.marklin.com.
• GB only:
Gebr. Märklin & Cie. GmbH
Reparaturservice
Stuttgarter Str. 55 - 57
73033 Göppingen
Germany
Tel: +49 7161 608 222
E-Mail: Service@maerklin.de
9