Installation Instructions - Climadiff CLE18 Manual De Utilización

4° INSTALLATION INSTRUCTIONS
Before using your wine cellar
•
Remove the inner and outer packaging.
•
Before connecting the cellar to the electrical socket, leave it in position for 24 hours. This will reduce the
possibility of malfunction of the refrigeration circuit due to transport.
•
Clean the inside using a soft cloth and lukewarm water.
Using your wine cellar:
Your wine cellar must be positioned in a room with an ambient temperature between + 16 and +38°C.
If the ambient temperature is higher or lower, the performance of your appliance may be affected and it may not
be possible to obtain temperatures between 5 and 22 degrees.
Installing your wine cellar
•
This wine cellar is designed for free-standing or built-in installation.
•
Position it in a place with sufficient strength to support its weight when loaded. To ensure that it is level,
adjust the height of the feet underneath.
•
To get the best from your appliance with the lowest energy consumption, do not place the appliance
close to a heat source (heater, cooker, etc.), do not expose it to direct sunlight, and do not place it in a
room which is too cold.
•
Connect the cellar to a single socket, leaving a 10 cm gap between the back of the cellar and the wall.
Be careful to support it, so that your wine cellar is perfectly level. (Use of a spirit level is recommended).
This will prevent any movement due to instability, causing noise and vibration, and will ensure that the
door seals perfectly.
Control panel
•
"RUN"
Power indicator
•
"LIGHT" Button
Lighting control button
•
"POWER" Button
On/Off switch
•
"DISPLAY"
Electronic temperature display
•
"UP" Button
+ Temperature setting button.
•
"DOWN" Button
- Temperature setting button.
•
"°C/°F" Button
- Reverse °C to °F.
.
28