Installation Instructions - Climadiff CLV Serie Manual De Utilización

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

The name plate attached to the inside or rear of the appliance (depending on the model)
includes all the information specific to your wine cellar.
We recommend that you make a note of its serial number in this booklet prior to installation,
so that you can refer to it later (technical work, request for assistance, etc.)
Once it is installed and loaded, access to it is not so easy.
CAUTION: No assistance can be provided without this information.

4. INSTALLATION INSTRUCTIONS

Before using your wine cellar
Remove the inner and outer packaging. Remove your wine cellar from the transport pallet
by unscrewing the two screws on the frame at the back of the device.
Before connecting the cellar to the electrical socket, leave it in position for 24 hours. This
will reduce the possibility of malfunction of the refrigeration circuit due to transport.
Clean the inside using a soft cloth and lukewarm water.
Using your wine cellar
Your wine cellar must be positioned in a room with an ambient temperature between
+10°C and +32°C. Alternatively, if the cellar is fitted with the winter system, the range is
extended to 0°C to 32°C.
Installing your wine cellar
This wine cellar is designed for free-standing installation.
Position it in a place with sufficient strength to support its weight when loaded.
To get the best from your appliance with the lowest energy consumption, do not place the
appliance close to a heat source (heater, cooker, etc.), do not expose it to direct sunlight,
and do not place it in a room which is too cold.
Plug the cellar into a single outlet.
Screw the stopper supplied inside the wine cellar to maintain a 10 cm minimum distance
between the back of the cellar and the wall in front of it is placed. Ensure that your wine
cellar is perfectly horizontal, then slightly raise the two front feet (use of a spirit level is
recommended). This will prevent any movement due to instability, causing noise and
vibration, and will ensure that the door seals perfectly.
59

Publicidad

Tabla de contenido
loading

Tabla de contenido