Publicidad
Idiomas disponibles
Idiomas disponibles
CAML16,
CAML21Z.
5.
Overview
Refer to the drawings on page 2 of this manual.
• [A] Flange adjustment ring, suitable for CS-mount
lenses. Use the included spacer for C-mount lenses.
• [B] Back focal lock screw. The camera is set at the
standard back focal position. Depending on the type of
used lens, slight adjustment may be necessary. Adjust
the lens back-focus by turning the focusing knob. Use
the included socket head wrench for this.
• [C] Auto iris lens connector. Supply power and control
signals to the auto iris lens.
• [D] Direct Drive Level Adjustment. When using a Direct
Drive Lens, the Direct Drive Level for video output
brightness can be adjusted.
• [E] Power LED indicator, is on during normal operation.
• [F] DC12V input. Connect a regulated 12VDC power
supply (not incl.) to provide power to the camera.
• [G] Video output connector to connect the camera to a
monitor (not incl.)
• [H] AES/AI selector. Switch to
(AES) when a fixed or manual iris lens is used with this
camera. Switch to Auto Iris (AI) when using an auto iris
lens.
• [I] Iris VD/DD selector. Set to Video Drive (VD) when
using a video drive auto iris lens, or to Direct Drive (DD)
in case a direct drive auto iris lens is used.
• [J] Audio output connector. Connect the audio in of the
monitor to this connector.
6.
Connection
• Mount a lens (not incl.) on the camera.
• Set the lens selection switch [H].
• Connect the video output [G] to the video input of a
monitor (not incl.). Use a 75Ω coaxial cable (not incl.).
• Connect the audio output [J] with the audio input of a
monitor (cable not incl.).
• Connect a 12VDC power supply (not incl.) to the power
input [F].
• When using a video driven lens, connect the video drive
cable (not incl.) to the auto iris lens connector [C]. If
necessary, replace the cable connector by the included
cable connector. Refer to the drawing on page 2 of this
manual for the pin layout. Replacing the connector should
be done by a qualified technician.
• To adjust the focus of the camera, loose the lock screw
[B] on the flange adjustment ring [A], turn the ring until
the desired focus is reached and retighten the lock screw
[B]. Adjusting the focus should be done by a qualified
technician.
00 (15/09/2008)
CAMSCC14
CAML17,
CAML18,
4
CAML19,
Auto Electronic Shutter
CAML20Z,
Publicidad
