Heath Zenith 5514 Manual De Instrucciones página 5

The detector is less sensitive to motion directly towards it.
Motion
Sensor
Least Sensitive
3. Loosen the clamp screw in the
sensor ball joint and gently
rotate the sensor.
4. Walk through the coverage
area noting where you are
when the lights turn on. Move
the sensor head up, down, or
sideways to change the cover-
age area. Keep the sensor at
least 1" (2.4 cm) away from
the lamps.
5. Adjust the SENSITIVITY as
needed. Too much sensitivity
may increase false triggering
6. Secure the sensor head's
aim by tightening the clamp
screw. Do not overtighten the
screw.
7. Set the amount of TIME you
want the lights to stay on after motion is detected
(1, 5, or 10 minutes).
WARNING - Risk of fire. Do not aim the bulbs
at a combustible surface within 3 ft. (1 m).
595-5730-07
Range . . . . . . . . . . . . . Up to 60 ft.(18.3 m) [varies with
Motion
Sensing Angle . . . . . . . Up to 110°
Electrical Load. . . . . . . 200 watt Incandescent [100
Power Requirements . . 120 VAC, 60 Hz
Operating Modes . . . . . TEST, AUTO and MANUAL
Most Sensitive
Time Delay . . . . . . . . . 1, 5, 10 minutes
Replacement lamp. . . . T3 100W halogen maximum
Clamp
HeathCo LLC reserves the right to discontinue prod-
Screw
ucts and to change specifications at any time without
incurring any obligation to incorporate new features in
Ball
products previously sold.
Joint
Aim Sensor
Down for Short
Coverage
Aim Sensor
Higher for Long
Coverage
5
SPECIFICATIONS
surrounding temperature].
Max each lamp holder].
MODE
120 VAC