Operation; Service; Service Guide - Swissmex 319310 Manual Del Operador

5
6
189305

OPERATION

4.
Compression sprayer:
Mix the solution in a separate container following the instructions of the product manufacturer.
Unscrew the pumping tube and remove it from the tank.
Pour the pre-mixed solution up to the indicated level marked in the tank.
Replace the pump tube and screw it tightly, then pressurize the unit.
Hold the sprayer by the handle or place it on the shoulder with the carrying strap and start applying.
Turn the nozzle to change the spray pattern (Solvent models 319310, 320305 & 322315).
Backpack sprayer:
Always use the strainer when filling the tank.
Mix the solution in a separate container following the instructions of the product manufacturer.
Pour the pre-mixed solution into the tank and place the lid.
Put the applicator on your back and pressurize it by pumping 15 to 20 times
Pump every 3 or 4 seconds to maintain the desired pressure.
For continuous application, secure the shut-off lever with the lock hook.
Turn the nozzle to change the spray pattern (Solvent model 189335).
5.

SERVICE

The applicator requires minimum maintenance. Follow in detail the steps mentioned in this manual and the useful life of the equipment will be very long. At the
end of your spraying job, don't leave the applicator with pressure, let all the pressure release through the nozzle, then remove the lid and the tank strainer
(backpack sprayer) or unscrew the pump handle (compression sprayer) and turn over the sprayer to empty the remaining solution in an appropriate container
for it. Now rinse the entire sprayer system with fresh water, as follows:
Pour ½ gal of fresh water into the tank and pressurize, flush the pumping system by depressing trigger at least 2 minutes, then remove the lid and the tank
strainer (backpack sprayer) or unscrew the pump handle (compression sprayer) and turn over the sprayer to empty the remaining water. Do this regularly and
it will prolong the life of gaskets and seals.
The carrying straps are made of non-absorbent material, however in case of spilling a solution you should wash the straps and tank with fresh water to
eliminate any possible risk of skin irritation.
Always follow the instructions for use of the products you are applying to avoid accidents and make the most of the product.
Always store the sprayer clean and empty in a dry place protected from the sun.
5.1

SERVICE GUIDE

To keep your sprayer in optimal condition, keep the following parts always greased: shut-off O rings, Piston sleeve, Pump tube O rings,
NOTE:
Plunger O rings, Nozzle O ring and pressure relief valve O ring.
Wash the sprayer inside and outside with fresh water, to be able to handle it without contamination risk.
It is recommended to replace all wear parts when performing a repair job:
- Piston sleeve, - Shut-off O rings,
- Nozzle O ring - Nozzle gasket and - Pressure relief valve O ring
- Pump tube O rings, - Plunger O rings,
5
189310
NOTE:
The pump tube must be tight
firmly otherwise the applicator
will leak and will not hold
pressure.
NOTE:
To ensure the best performance
use only "SWISSMEX-RAPID"
original spare parts.
NOTE:
To ensure the best performance
use only "SWISSMEX-RAPID"
original spare parts.