Using The Machine - Garland MONTANA 110 Manual De Instrucciones

English
6.5.2. CHECK OF THE AUTOMATIC CHAIN LUBRICATION
You can adjust the oil flow with
the adjusting screw (1) oil that
is below the chainsaw next to
the clutch.
To regulate oil flow turn the screw clockwise "MAX"
If you want to increase it, or turn the screw 'MIN' to
decrease it. The indications "MAX" and "MIN" are at
the bottom of the machine. Be sure to fill the chain oil
tank whenever refilling fuel.
6.5.3. CHECK OF PROTECTION AGAINST BOUNCING
Bouncing of the machine is the greatest
risk of this machine.
This machine has an automatic brake to stop the
rotation of the chain where a rebound occurs during
use.
6.5.4. CHECK OF THE SECURITY BRAKE
Accelerate the chainsaw to its maximum revs and
push the safety brake lever forward. The chain should
stop immediately with the engine at full power.
If the chain not is for or takes to stop take the
machine for service. Check the emergency brake
whenever you start using the machine.
After starting the engine,
speed up the chainsaw
until the chain turns at an
average speed and check if
the chains saw greases the
chain, this will be easily seen
when you place the chainsaw
as in the figure, oil will come
out.

7. USING THE MACHINE

Use this machine only for the designated
purposes. Using this chainsaw for any other use is
dangerous and can cause bodily harm and/or damage
to the machine.
Do not approach the chain when the motor is
running.
Do not trust only in the security measures of this
machine.
Do not use this machine if you are fatigued,
ill, or are under the influence of medication,
drugs, or alcohol.
Fatigue and the lack of rest can cause accidents or
damage. Limit continued use of this machine to 10
minute time intervals and rest for 10-20 minutes to
rest between each session.
Always hold the chainsaw with the two
hands and keep subject handles while the
engine is on unless you are performing
a pruning height with rope and harness. If you firmly
hold the machine by the handles will reduce the
risk of rebound and will increase its control over the
machine.
Remember to always use the machine with clean
hands and without any fuel or oil.
Pay special attention if you use this machine in the
rain or after raining, as the soil will be slippery and
you may slip.
If you slip or fall, stop accelerating and move the
switch to the position "O" (shutdown).
50/160