Cequent Performance Products 24839 Instrucciones De Instalación

Hitch Shown In Proper Position
Equipment Required: Torque wrench
Fastener Kit: 24839F
Wrenches: 17mm Socket and Ratchet Wrench
Phillips screw driver
Drill Bits: None
1
2
1 1 1 1
Qty. (4) Hex Bolt, M10 x 1.25 x 30mm CL8.8
1. Lower exhaust by removing the rubber exhaust hanger.
2. Remove the inner wheel well and splash guards from vehicle, both sides.
3. Remove tow hook from passenger's side frame rail and return to vehicle owner.
4. Raise hitch into position and loosely install the M10 bolts and conical toothed washers as shown.
5. Pull hitch rearward and tighten all fasteners using a torque wrench as specified below.
6. Reinstall muffler hanger.
7. Reinstall the inner wheel well and splash guards.
Tighten all M10 CL8.8 fasteners with torque wrench to 42 Lb.-Ft. (57 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z 2009, 2012, 2013, 2015 Cequent Performance Products – Printed in México
Installation Instructions
Kia Soul
Fascia
(Sold separately)
Drawbar Kit:
3593
Drawbar must be used in the
RISE position only.
EXISTING WELDNUTS
Do Not Exceed Lower of Towing Vehicle
2000 LB (908 Kg.) Max Gross Trailer Weight
200 LB (90.8 Kg.) Max Tongue Weight
Wiring Access Location: SUV1, SUV2
1
2
REMOVE FASTENERS
INNER WHEEL WELL / SPLASH GUARD
2 2 2 2
Qty. (4) Conical Toothed Washer 3/8"
Sheet 1 of 3 24839N
Part Numbers:
24839
60256
24792
(U-Haul)
77230
Manufacturer's Rating or
10-8-15 Rev. G