General Safety Information - Campbell Hausfeld PA211200AV Instrucciones De Funcionamiento Y Manual De Piezas

Operating Instructions and Parts Manual
Please read and save these instructions. Read carefully before attempting to assemble, install,
operate or maintain the product described. Protect yourself and others by observing all safety
information. Failure to comply with instructions could result in personal injury and/or property
damage! Retain instructions for future reference.
General Safety
Information
calIFoRnIa PRoPosItIon 65
contain chemicals, including lead, known
to the State of California to cause cancer
and birth defects or other reproductive
harm. Wash hands after handling.
You can create dust when
you cut, sand, drill or grind
materials such as wood,
paint, metal, concrete, cement, or
other masonry. This dust often contains
chemicals known to cause cancer, birth
defects, or other reproductive harm.
Wear protective gear.
GeneRal saFety
This product is a part of a high pressure
system and the following safety
precautions must be followed at all times
along with any other existing safety rules.
Read this instruction manual
before installing this device
to the air supply system. Be
thoroughly familiar with the
controls and the proper use of the
equipment.
Safety glasses must be worn
during operation.
1. Always work in a well ventilated area.
2. Do not exceed any pressure rating of
any component in the system.
3. Protect air lines from damage and/or
punctures.
2
This product or
its power cord may
MANUAL
www.campbellhausfeld.com
4. Check air hoses for weak or worn
condition before each use. Make sure
all connections are secure.
5. Keep all nuts, bolts and screws tight
and ensure equipment is in safe
working condition.
This product is specifically
designed for compressed
air service ONLY. Use with any
other material (liquid or gas) is a
misapplication and not permitted. Use
or injection of certain hazardous liquids
or gases in the system (such as oxygen,
alcohol or liquid petroleum gas) will
harm the unit and result in a combustible
condition or hazardous external leakage.
Misapplication will void all warranties
and manufacturer's responsibilities.
Installation
Disconnect power and release
all pressure from the system
before attempting to install,
service, relocate or perform any
maintenance.
1. Locate the air flow direction arrow
(See Figure 2, detail). This arrow
shows the direction of the air flow.
2. Securely mount the lubricator in a
vertical position as close as possible
to air tool connection.
3. Verify the arrow points in the direction
of the air flow (See Figure 2.)
4. Install the unit with the same pipe
size as the piping in use. Avoid using
unnecessary fittings, couplings, etc.,
that restrict airflow.