Troubleshooting; Figures (Illustrations); Warning - RIDGID R250AF18 Manual Del Operador

OPERATION
REMOVING NAILS FROM THE TOOL
See Figure 10, page 14.
 Remove the battery pack from the tool.

WARNING:

Remove the battery pack from the tool before
removing nails. Failure to do so could result in
serious personal injury.
 To r e mo ve a str ip o f nails f r o m the to o l, ho ld the f inish
nailer by the handle with your right hand, and rest your
left hand underneath the tool with your left thumb on the
pusher.
 Depress the inside lever on the pusher to release and
allow the pusher to slowly slide to the front.
NOTE: Always keep fingers clear of nail track of magazine
to prevent injury from unintended release of the pusher.
 Slide the nails toward the back of the magazine and
remove.

TROUBLESHOOTING

PROBLEM
Tool jams frequently
Tool stops working
Motor runs but tool will not fire
NOTE: MAINTENANCE INFORMATION BEGINS ON PAGE 12
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
These products have a 90-Day Satisfaction Guarantee Policy, as well as a
For Warranty and Policy details, please go to www.RIDGID.com
POSSIBLE CAUSE
Incorrect fasteners
Damaged fasteners
Loose magazine or nose screws
Dirty magazine
Worn or damaged driver
Battery voltage is low
Battery needs charging
Worn or damaged drive mechanism
FIGURES (ILLUSTRATIONS) START ON PAGE 13.
Three-year Limited Warranty.
or call (toll free) 1-866-539-1710.
CLEARING A JAMMED FASTENER
See Figure 11, page 14.
WARNING:
Remove the battery pack from the tool before
clearing a jammed fastener. Failure to do so could
result in serious personal injury.
If a nail or fastener becomes jammed in the tool, remove
the battery pack and keep the tool pointed away from you
while clearing the jam.
 Remove the battery pack from the tool.
 Remove fasteners from the tool.
 Pull up o n the latch and o pe n the jam r e le ase .
 Insert a flat blade screwdriver into the driving mechanism
and push the driver mechanism back, freeing the fastener
jam.
 Remove the bent fastener.
 Close the jam release and latch.
 Reinstall the battery pack.
 Reinstall fasteners and close the magazine.
11 - English
SOLUTION
Verify that fasteners are the correct size
Replace fasteners
Tighten screws
Clean magazine
Install Driver Maintenance Kit
Remove battery and reinstall to reset.
Battery must be recharged soon after.
Replace or recharge battery.
Clean or replace drive mechanism.