Fanimation AIREDROP LP8069 Serie Manual Del Usuario página 16

How to Assemble Your Light Kit (continued)
3. Remove the three screws in the light kit and retain
the screws for later. (Figure 3)
4. Connect the 2 single pin connectors from the LED
assembly to the 2 single pin connectors from motor
assembly. (Figure 4)
5. Assemble the LED assembly to the light kit using
the removed screws from Step 3 and secure all three
screws. (Figure 5)
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
6. Secure the glass to
clockwise direction. Do not over-tighten. (Figure 6)
light kit by twisting in a
Light Kit
Motor
Assembly
Light Kit
LED Assembly
Light Kit
16
Figure 3
LED Assembly
Figure 4
Figure 5
Glass
Figure 6