Publicidad
Idiomas disponibles
Idiomas disponibles
Symmetry Signature Railing
Installation Instructions -
6-ft. and 8-ft. Line (cont.)
17
Secure the top brackets with the supplied
#10 x 2-1/2-in. screws.
18
Position the top rail over the infill assembly and
carefully lower into place.
19
Using supplied 1-7/8-in. screws, secure
the top rail starting as close to the post as
possible. Space the remaining screws evenly.
20
Complete the assembly by gluing the post
caps in place with a quality exterior-grade
adhesive.
5
Please visit https://www.fiberondecking.com/resources/installation-instructions or call Consumer and Technical Support at 800-573-8841.
Symmetry Signature Railing Installation Instructions - Angled Line
Note: Angled installations require a
minimum 5x5 post.
1
Deck Side
For angled line installation, the line brackets
must be installed with the angled edge on
the deck side of the railing.
Note: This is opposite of what is indicated
on the line bracket for basic line railing
installation.
2
7/32-in. - 1/4-in.
The template can still be used to locate
the height of the line bracket. The side-to-
side alignment needs to be approximately
7/32-in. – 1/4-in. off-centered from the
deck side of the railing for a full 45-degree
installation.
Note: If the bracket is not offset slightly,
the top rail may overhang the corner post
face and extend into the corner chamfer.
The most recent installation instructions can be found on our website.
3
Secure with supplied #10 x 2-1/2-in. self-
drilling screws. Do not over-tighten.
4
Aligning feature
Ensure that the bottom rail is positioned
correctly prior to cutting the bottom rail
angle for installation. The bottom rail has an
Yard Side
aligning feature on the top, which should be
on the yard side of the rail opposite to the
deck side.
5
Center the hole pattern in the bottom rail
between the posts. Transfer length and
angle to the top rail and cut both top and
bottom rails. When aligning the hole pattern,
transferring length, and cutting angles on
the H-bar, remember to subtract 7/32-in.
from each end to allow for top brackets.
Yard Side Deck Side
Publicidad
