Publicidad
Idiomas disponibles
Idiomas disponibles
Symmetry Signature Railing Installation Instructions - 6-ft. and 8-ft. Stair
7
To cut the H-bar, first place the H-bar on
its side with the holes nearest to the cut
bottom rail. The bottom rail should be top
side up. Align the hole pattern with the cut
bottom rail.
8
Transfer the length of the cut bottom rail to
the H-bar.
9
Scribe the stair angle to the side of the
H-bar at both ends.
Please visit https://www.fiberondecking.com/resources/installation-instructions or call Consumer and Technical Support at 800-573-8841.
10
The total length of the H-bar will be 7/16-in.
shorter than the cut bottom rail.
Scribe a second line 7/32-in. inside the first
at both ends.
Note: This allows for the thickness of the
upper bracket.
11
Position the top brackets into the H-bar,
ensuring that they are inserted completely.
12
Secure the top brackets to the H-bar using
(two) 5/8-in. self-drilling pan head screws. Do
not over-tighten.
The most recent installation instructions can be found on our website.
13
Square Composite Balusters: Remove the
baluster guide from the rail box. Place on a
flat surface and insert the balusters into the
precut slots.
Round Metal Balusters: Place cut bottom rail
on a flat level surface. Align the cut-end of
the round metal baluster with the top surface
of the bottom rail.
14
Square Composite Balusters: Align the end
baluster with the predrilled hole in the bottom
rail. Secure the balusters using the supplied
#10 x 1-1/2-in. screws.
Hold each square composite baluster
securely against the aligning feature and
drive screws parallel with the balusters, not
perpendicular to the bottom rail. Do not over-
tighten.
Round Metal Balusters: Insert the screw into
the center "X" of the end baluster. It may be
necessary to slightly over-drill the factory-
drilled holes by rocking the moving bit parallel
with the direction of the rail. Do not over-
tighten.
Continue working from one end until all the
balusters are secured into the bottom rail.
8
Publicidad
