Pentair Intellibrite 5g white led Guia De Instalacion página 7

Replacing the IntelliBrite White Pool or Spa
(after electrical requirements are met)
The following removal and installation instructions describe how to remove and
install the IntelliBrite Pool or Spa white light assembly. Also use these instructions
after completing the following light replacement procedure:
Failure to bring the pool or spa's electrical system up to code requirements
before installing the underwater light will create an electrical hazard which
could result in death or serious injury to pool users, installers, or others due to
electrical shock, and may also cause damage to property.
1. WARNING! Switch off main electrical switch or circuit breaker, and the
switch which operates the IntelliBrite underwater light.
2. To remove light fixture assembly from the pool. Remove the special
bronze pilot screw at top of face ring. Remove the IntelliBrite light assembly
from the niche and place it on the deck.
3. Cut the cord about 30cm from the back of the light assembly.
4. Remove Junction Box cover, disconnect the light fixture wires, and
pull the cord through the conduit. Tip: Before pulling the cord, tape
the new cord to the existing cord, This might make it easier to
feed the new cord through the conduit (see following step).
5. Feed the new light fixture cord through the conduit from the niche
to the Junction Box. Note: Depending on the length of the conduit,
special tools may be required to pull the cord through the conduit.
6. Leave at least 1meter of cord to coil around the light fixture; see
Figure 1. This 1 meter of cord coiled around the light allows the light
to be serviced after the pool is filled with water.
7. Cut the cord at the Junction Box, leaving at least 15cm of cord to
make connections.
8. Strip 15cm of the outer cord jacket from the cord to expose the three
insulated wires – Be careful not to damage the insulation on the
three inner wires.
9. Connect the two wires to the corresponding circuit wires in the
Junction Box (brown wire to power, Blue wire to common) and
secure the Junction Box cover in place.
10. Install the IntelliBrite light assembly into the niche and tighten the special
bronze pilot screw.
LED Light Assembly
7