Connecting To A Dante Network - Tascam IF-DA64 Manual Del Usuario

When in switched (daisy chain) mode, use to connect
another Dante device in the chain.
Link status/activity indicator
3
Green indicates that a link is established between the
devices.
Blinking indicates that signals are being transmitted between
the devices.
Gigabit link status indicator
4
Orange indicates that a gigabit Ethernet link has been estab-
lished.
8
TASCAM IF-DA64

Connecting to a Dante network

In order to set up and use this card, you must also set up the
Ethernet network that it is connected to, a computer that runs
Dante Controller and other devices that support Dante.
8 LAN cables used for connections
Use LAN cables that are category 5e or faster.
Both crossover and straight cables can be used.
CAUTION
•
This unit is not compatible with 100Mbps Ethernet
switching hubs. Always use switching hubs that support
Layer 2 and Gigabit Ethernet.
•
Two of these cards cannot be installed in a DA-6400 and
used at the same time. It two of these cards are installed,
only the one in SLOT 1 can be used.
NOTE
•
Set the computer to set the IP address automatically.
•
Restarting the computer might be necessary if a previous
network setting is still active on the computer.