Mounting On A Mic Stand - Roland MOBILE BA Manual Del Usuario

Mounting on a Mic Stand
By using a mic stand, you can mount the MOBILE BA
at the optimal height for use as a monitor speaker or
simple PA device.
The mic stand holder (the hole diameter) is compatible
with both 3/8-inch and 5/8-inch types.
If you're using the MOBILE BA with a 5/8 inch mic stand,
remove the mic stand adaptor from the bottom of the
unit.
NOTE
• When placing the MOBILE BA upside down, take care not to damage the buttons or knobs, and be
careful not to let it fall or tip over.
• If you're not using a mic stand, be sure to attach the mic stand adaptor to prevent leakage of sound
(air).
Requirements when using a mic stand
As shown in the illustration, you must use a mic stand
that can be lower than 125 cm (49-1/4"; including the
MOBILE BA), and whose legs will be 63 cm (24-13/16")
or more when opened to a maximum width.
NOTE
• Using a mic stand that does not meet the specifications above may result in damage to equipment or
injury due to the stand tipping over.
• When using MOBILE BA with a mic stand, the mic stand must be carefully placed so it is level and sure
to remain stable.
• Cables connected to MOBILE BA should be given enough slack to prevent accidents that might result
from someone tripping over them.
• To prevent accidents due to falls, do not place any object on the MOBILE BA when it's mounted on a
mic stand.
• After attaching the MOBILE BA to the mic stand, check to make sure that it is stable before you use it.
8
Mic stand adaptor
Mic stand holder
125 cm
(49-1/4")
or less
63 cm (24-13/16") or more