Garland GAS 359 E Manual De Instrucciones página 25

2.2.2. VIBRATIONS
The prolonged use of the machine, exposes the
client to vibrations that in extreme cases and through
many hours of use of the machine could cause the
¨white finger syndrome¨ also known as Raynaud
phenomenon. This causes a reduction in the tact of
the fingers and their capacity to regulate temperature
generating a lack of sensibility. This sickness could
in extreme cases cause problems with the nerve
endings.
The exposure to the vibrations is the cause of
the white finger syndrome. To minimise this
effect as much as possible, follow the following
recommendations:
• Always use gloves
• Always have your hands warm
• Take frequent breaks
• Always hold the machine tightly by the handles
If you detect any of the symptoms of the white finger
syndrome, consult immediately with your doctor.
2.3. WORKING AREA SECURITY
Do not use the machine in explosive atmospheres
or in the presence of inflammable liquids, gases and
powders.
Electric machines can release sparks that
could ignite the inflammable liquids, gases
and powders.
When working on the street, road or areas close to
them please ensure that you do not blow material onto
the road or street.
The working area has a 15 metre radius around the
machine and should be considered a risk area were
nobody should enter whilst the machine is working
(security area). When necessary, use rope or signals to
mark the working area.
Maintain children, other people and animals well clear
of the machine whilst working. Distractions can cause
the loss of control. Be vigilant and stop any children,
other people and animals coming into the working
area.
When work must be carried out by two or
more people at the same time make sure
you can control and see the other people so as to
maintain an adequate working distance between users
to guarantee security.
Do not use this machine when there are other
unprotected persons in the work area. Other persons
must wear goggles, ear protectors and gloves at all
times.
Do not use this machine at night, with fog or with
reduced visibility that does not allow you to see the
working area.
Maintain the work area clean and work under well lit
conditions. Only use this machine in daylight or good
artificial
light. Untidy and dark working areas, cause accidents.
Check and remove all objects that may cause
damages to you or to your machine.
2.4. ELECTRICAL SECURITY
Connect this machine to alternate current 230v/50Hz.
Do not expose this machine to rain or humid
conditions. The water that enters the machine will
increase the risk of electric shock.
Never cut the cable. There is a risk of electric shock
and also of damaging the machine.
25/104
English