Maintenance And Service - Garland GAS 359 E Manual De Instrucciones

7.2. SPEED REGULATION
This machine has a speed regulator
with which you can control the
speed of the blowing air and that
of the vacuum air. To regulate the
speed turn the regulator right or left
depending on whether you want more or less speed.
7.3. WORKING WITH THE BLOWING FUNCTION
Always follow the security stipulations that we indicate
in the manual.
Place the lever in the blowing position.
Start the machine with the machine on the ground,
place it on your back, adjust the accelerator to the
desired speed and aim the air flow towards the leaves
and materials to be pushed. Push all the material
towards one place which preferably should be a corner.
Once all the material has been grouped for pick up,
turn the machine off, switch to vacuum function, start
the machine again and begins to suck the materials.
7.4. WORKING WITH THE VACUUM
Always follow the security stipulations that we indicate
in the manual.
Place the lever in the vacuum position.
Start the vacuum, adjust the machine to the required
speed and vacuum the material.
When you feel the catcher is full, stop the machine,
unplug the machine from the mains, disconnect the
catcher and empty it.
Once the catcher is empty, connect again before
starting to work again.
If you are going to vacuum large leaves, you can
remove the nozzle situated at the end of the tube.
7.5. AFTER USAGE
Once you stop using the machine.
1. Disconnect the machine by placing the switch
in the ¨O¨ closed position.
2. Disconnect the machine from the mains.
3. Clean any residues from the catcher and the tubes.
4. Open the ventilator cover, remove any residues
from the blades and close the ventilator cover
again.
.

8. MAINTENANCE AND SERVICE

Carry out random inspections on the machine to
ensure an efficient use of the machine. For a
complete maintenance take the machine to your
nearest service agent.
Never attempt to carry out any maintenance work
on the machine if the machine is running. Carry out
.
all maintenance work on a flat surface and on a clear
surface.
Always carry out all the maintenance work with
the machine unplugged from the mains.
Read the instruction manual before carrying out
any maintenance work.
Maintain the machine clean, specially the ventilating
areas of the engine.
35/104
English