Adding / Removing Clothes During A Cycle - Avanti CTW84X0W-IS Manual De Instrucciones

To select one of the pre-programmed automatic wash cycles follow the instructions as shown
below:
·
Close the lid.
·
Press the power button.
·
Press the program button to select the appropriate program until the program number is
shown in the display window. (Cotton is the default program)
·
For routine / normal washing it is recommended to use the NORMAL program and only use
the HEAVY SOIL setting for large loads or when washing items that are excessively soiled.
·
Press the water level button to select the appropriate water level setting. (The default water level
is 3 water level)
·
Press the START/PAUSE to start the cycle. And the LED display will show the remaining time of
the entire course.
In the event the clothing being washed becomes unbalanced, the safety switch will be activated, and
the washing machine will automatically refill with water to adjust the imbalance.
Note:
·
Clothes easily discolored should be washed separately so as to prevent inter-dyeing.
·
If you want to change a selected program, press the POWER button first to turn the unit off, then
press the POWER button again to turn the unit back on, then press the Program button to select
the new cycle before pushing START/PAUSE button.
·
When the Rinse and Spin functions are ON, do not use detergent.
·
If you want to drain the water during washing, press the POWER button first to turn the unit off,
then press the POWER button again to turn the unit back on, then select the SPIN function. Press
START/PAUSE button again to restart.
ADDING / REMOVING CLOTHING AFTER THE CYCLE HAS STARTED
Your washing machine is equipped with a safety system that will stop the machine when the
lid is opened during a wash cycle.
To add or remove clothing to/from a wash cycle follow the steps below:
·
Open the lid, the machine will stop (E2 will flash in the display and a beep will sound).
·
Add or remove the clothing as needed.
·
Close the lid.
·
Press the Start / Pause button to continue the previous wash cycle.
DELAY START
Your machine can be programmed to start at a later time, to activate the delay start program (2 – 24
hours) follow these steps:
Press the Power button.
Select the desired wash program by pressing the program button until the wash program number is
shown in the display window.
Press the load size button to select the size of laundry load to be washed.
Hold the Load size button for approximately 3 seconds, "2" will be shown in the window, press the
load size button to select the desired start time.
Press the START / PAUSE button to activate.
The preset start time and ( • ) will flash in the display window. Once the delay time has elapsed, the
washer will begin the pre-programmed wash cycle.
Rinse + (Additional Rinse Option)
During the wash cycle you can select the additional rinse option, this will add up to two additional
rinses.
Press and hold the PROGRAM button, the unit will beep and "2" will flash in the display window.
Press and select the appropriate number of rinses desired. (2 – 4).
Press the START / PAUSE button.
18