General; Dimensiones Principales - Vetus BTANK25C Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 19
1
Introduction
These instructions apply to the Vetus rigid plastic waste water tanks
for grey water and black water.
When installing a waste water tank, the European Recreational Craft
Directive (RCD, 2013/53/EU) and any national legislation must be ob-
served. Use the ISO 8099 standard as a guide.
Grey water tank
- A grey water tank should only be used for collecting water from
the sink, shower, wash basin, air conditioning, etc..
- The capacity of a waste water tank can never be too large.
- Match the capacity to the amount of fresh water available; the
capacity of the water tank(s).
- Fit sink, shower, wash basin, etc. with a drain with sieve, so that
coarse waste, such as hair etc., will be less likely to enter the grey
water tank.
Black water tank
- A black water tank is used only for temporary collecting toilet
waste.
- The capacity of a waste water tank can never be too great.
- The capacity should be calculated using the amount of flushing
water (outside water) used by the toilet. Reckon on 7 to 14 litres
(1.5 to 3 Imp. Gal., 1.9 to 3.8 US Gal.) of black water per person
per day.
2
Installation
2 1

General

When choosing a place for the tank and for the deck filler cap, take
the following into account:
- The suction hose should be as short as possible, must go directly
down to the tank and be as straight as possible.
- The space in which the tank is placed should be properly venti-
lated.
Position
• Position the tank as close as possible to the toilet to avoid dirty
water flowing back into the toilet from the tank when the boat
heels.
• Install the tank so that it is easily accessible for inspection.
• Also ensure that there is sufficient free space over the top of the
tank for the hose connections. These must be easily accessible
during installation. The tank should be 1 cm (3/8") free all round
from bulkheads or other tanks, to provide ventilation.
Riged waste water tanks 25 l
- Use only water-soluble toilet paper to prevent unnecessary block-
ages. Sanitary towels and tampons in the toilet and black water
tank will certainly cause blockages.
Clearing a blockage is an unpleasant job, make sure you have a pair
of rubber gloves on board.
Smell
Grey water tank
- Unpleasant odours will be produced in every grey water tank. Fit
the sink, shower, wash basin, etc., with an S-bend (siphon or stink
trap) and a plug.
Black water tank
- Unpleasant smells caused by faeces will be produced in every
blackwater tank. The use of sea water for flushing will increase the
smell. The algae in sea water also produce unpleasant smells.
- It is possible to add special additives to waste water tanks to re-
duce the smell, called tank deodorants. A simple way of reducing
the smell is by using washing soda, which cleans and sterilizes.
- Leaking hoses, hose fittings, tanks, tank covers, etc., can also cause
a smell nuisance. So carry out a regular check of the whole system.
For dimensions, see drawing on page 27. Tolerances of +/- 2% apply
to all tank dimensions!
The height difference between the tank and the filler cap may
a maximum of 2 metres (6'8") (the maximum excess pressure in
the tank is 20 kPa ( 0.2 bar, 3 psi )!)
70 mm (2
3
/
˝)
4
70 mm (2
3
/
˝)
4
ENGLISH
N
ote
± 30 mm (1
3
/
˝)
16
110135.01
7

Publicidad

Tabla de contenido
loading

Tabla de contenido