Bosch UniversalMulti 12 Manual Original página 19

is discharged, the power tool is switched off by means of a
protective circuit: The application tool no longer rotates.
Do not continue to press the On/Off switch after the
u
power tool has automatically switched off. The battery
can be damaged.
To remove the battery (3), press the battery release button
(4) and pull the battery to the rear and out of the power tool.
Do not use force to do this.
Battery charge indicator
The battery charge indicator (6) indicates the remaining bat-
tery capacity or an overload when the power tool is switched
on.
LED
Green continuous light
Yellow continuous light
Red continuous light
The following table shows examples of application tools. You can find additional application tools in Bosch's extensive range of
accessories.
Application tool
Bi-metal segment
saw blade
Sanding plate for
Delta series 93 mm
sanding sheets
Profile sander
Bi-metal plunge cut
saw blade for wood
and metal
HCS plunge cut
saw blade for wood
Bosch Power Tools
If the battery charge indicator (6) flashes red, the power tool
is overloaded (see "Temperature-dependent overload pro-
tection", page 23).
Changing the tool
u
Selecting an Application Tool
Please observe the application tools intended for your power
tool.
Application tool
Capacity
> 70%
30–70%
< 30%
Material
Wood-based materials,
plastic, non-ferrous
metals
Depends on the sanding
sheet
Wood, pipes/profiles,
paint, varnish, filler, metal
Softwood, soft plastics,
plasterboard, thin-walled
aluminium profiles and
non-ferrous metal pro-
files, thin sheet metal,
non-hardened nails and
screws
Wood-based materials,
soft plastics
Wear protective gloves when changing tools. There is
a risk of injury when touching the application tools.
Application
Separating cuts and plunge saw cuts;
including sawing close to edges, in corners and in difficult-
to-reach areas;
example: Shortening skirting boards that are already in-
stalled or door frames, plunge cuts when adapting floor
panels
Sanding surfaces at edges, in corners or in difficult-to-
reach areas;
depending on the sanding sheet, e.g. for sanding wood,
paint, varnish, stone;
fleeces for cleaning and for texturing wood, removing rust
from metal and for keying varnish, polishing felt for pre-
polishing
Convenient and efficient sanding of profiles up to a dia-
meter of 55 mm;
red sanding sheets for sanding wood, pipes/profiles, var-
nish, filler and metal
Small separating cuts and plunge cuts;
example: Cutting a recess for sockets, cutting a copper
pipe so that it is flush with a surface, making plunge cuts in
plasterboard
Delicate adaptation work in wood;
example: Sawing recesses for locks and fittings
Separating cuts and plunge saw cuts;
including sawing close to edges, in corners and in difficult-
to-reach areas;
example: Thin plunge cut in solid wood for installing a
ventilation grille
English | 19
UniversalMulti 12
1 609 92A 4N3 | (16.10.2018)