Before First Use - Klarstein MKS-3 Manual Del Usuario

Setting the Temperature Control
• Press the LIGHT button to turn the interior light on or off. The light turns off
automatically after 10 minutes. To turn it back on, press the light button again.
• Press and hold the °F/°C button for 2 seconds to change from Celsius to
Fahrenheit.
• The unit is equipped with an automatic key lock that is automatically activated 20
seconds after the last key press. To unlock the keys, press and hold
until a beep sounds.
• Briefly press the button once to set the upper zone temperature.
• Briefly press the button twice to set the lower zone temperature.
• Use the ARROW KEYS to set the desired temperature. Each time the button is
pressed, the temperature will increase/decrease by 1 °C.

BEFORE FIRST USE

• Remove the exterior and interior packing.
• Check to be sure you have all of the shelves.
• Clean the interior surface with lukewarm water using a soft cloth.
Installation of Your Wine Chiller
This Wine Chiller is designed to be free standing installation only, and should not be
recessed or built-in (Fully recessed). Place your Wine Chiller on a surface that is strong
enough to support it when it is fully loaded. Allow 5 inches of space between the back
and sides of the wine chiller, which allows the proper air circulation to cool the heat sink.
Locate the Wine Chiller away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption. Extreme cold ambient tem- peratures may also cause
the unit not to perform properly.
After plugging the Wine Chiller into a wall outlet, allow the unit to cool down for 2-3
hours before placing any items in the compartment.
for 2 seconds
EN
21