Use And Operation; Cleaning And Care - Klarstein 10029463 Manual Del Usuario

Before first Use
• Remove the exterior and interior packing
• Before connecting the appliance to the power source, let it stand upright for approximately 2 hours. This will
reduce the possibility of a malfunction in the cooling system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• Place your appliance on a floor that is strong enough to support the appliance when it is fully loaded. To level
your appliance, adjust the front legs at the bottom of the appliance.
• Foe recedes installation away from direct sunlight and sources of heat (stove, heater, radiator, etc.).Direct
sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold
or hot ambient temperatures may also cause the appliances not to perform properly.
• Not designed for placement in adage or basement.
• The appliance is for indoor use only.
Operation
It is recommended that you installed the wine refrigerator in a place where the ambient temperature is bet-
ween 10-25 .If the ambient temperature is above or below recommended temperatures, the per
of the unit may be affected. The temperature may fluctuate depending on whether or not the inte
is on or off or whether the bottles are located on the upper, middle or lower section.
How to set temperature
There are three touch-buttons on the control panel:
• Use the arrow buttons to increase or decrease the set temperature by 1°C .
• Use the light button to turn on or off the interior light.
Notes on cooling
• This product is designed for max imum cooling of 14°C below ambient temperature.
• When the ambient temperature around 25°C or less, unit can maintain a temperature range between 11-18°C.
Cleaning
• Unplug the wine cooler and remove the bottles.
• Wash the inside with a warm water and baking soda solution. The solution should be about 2 tablespoons
of baking soda to a quart of water.
• The outside of wine cooler should be cleaned with mild detergent and warm water.
• Draw out the water box at the bottom, and wash.
Moving your wine cooler
• Remove all the bottles.
• Securely tape down all loose items inside your wine cooler.
• Turn the leveling legs up to the base to avoid damage.
• Tape the door.
• Be sure the wine refrigerates stays in the upright position during transportation.

Use and Operation

Cleaning and Transport
formance
rior light
8