ABC Design Mamba PLUS Instrucciones De Uso página 12

Customer complaints
• No claims may be made for natural wear and tear or for damage caused by undue demands on the product
or by exceeding the permissible load.
• No claims may be made for damage caused by improper use.
• No claims may be made for damage caused by incorrect assembly or operation.
• No claims may be made for damage caused by improper modifications to the product.
• Areas of rust may appear through lack of maintenance or improper care and do not constitute a fault with
the product.
• Scratch marks are normal signs of wear and do not constitute a fault with the product.
• Mildew is likely to appear on textiles which are not dried out after getting wet and cannot be attributed to
shortcomings in production conditions.
• The product may fade if exposed to sunlight, perspiration and detergents, or if subject to abrasion or
excessive washing, therefore fading cannot be attributed to a fault with the product.
• No claims may be made for wheels which become worn out as a natural result of wear and tear.
1. Opening the pushchair
a. Press and hold the release mechanism buttons on both sides of the pushbar. Pull the release
mechanisms up.
b. Pull the bar-type handle up until the frame engages.
CAUTION: Ensure that all the catches are engaged before use.
2. Adjusting the pushbar height
Press and hold in the buttons on the pushbar and move it to the required position.
3. Attaching and removing the rear wheels
a. Press in the button on the end of the axle and fit it in the wheel.
b. Press in the button on the end of the axle and mount it with the wheel into the fitting on the frame.
c. To remove the wheel, press in the button on the end of the axle and pull it out of the fitting.
4. Attaching and removing the front wheels
a. Push the front wheels into the fittings on the frame.
b. To remove the front wheels, press in the buttons above them and pull them out of the fitting.
5. Front wheel locking and swivel settings
Press the buttons to move the front wheels to swivel setting. Press the buttons again to move the front
wheels to the lock setting.
6. Operating the brake
a. Press the button on the handle block to activate the parking brake.
b. To disengage the parking brake, press and hold the button and pull the brake lever backwards.
7. Adjusting the suspension
a. Move the suspension cover to the left or right to adjust the spring compliance.
b. The three settings are marked on the suspension.
NB: Make sure that both springs are on the same setting before using the
pushchair.
EN - 06