Technical Specifications; Troubleshooting - Vivanco FMH 7190 Instrucciones De Uso

Charging the supplied rechargeable batteries
1. Switch off the RF headphone.
2. Place the RF headphone in the charging tray with the side marked "L" to the left.
3. Charging of the rechargeable batteries starts automatically and the charging
indicator light of the charging tray switches to red.
4.
Note: Before the first use, charge the rechargeable batteries continuously
for 15 hours in order to obtain the full capacity.
The RF headphone has a protective charging function for longer battery life. After approx.
15 hours the discharged batteries are fully charged again.
You can now enjoy music again for approx. 14 hours at an average volume.
Using different batteries
The RF headphone can also be used with other chargeable standard AAA micro batteries
or non-chargeable 1.5 V AAA batteries. Standard chargeable AAA micro batteries cannot,
however, be charged via the devices.
Disposing of the batteries and rechargeable batteries
Consider the environment when disposing of the batteries or rechargeable batteries,
which must not be thrown away with domestic rubbish. Do not use old and new batteries
or different battery types simultaneously. Remove batteries from the device if it is not to
be used for a long time.

Technical specifications

No. of channels:
Frequency range:
Modulation:
Power supply:
Transmitting power:
Operating temperature:
Subject to alteration.
Trouble-shooting
If your device should not function properly, please proceed as follows:
1. Using the following table of malfunctions, try to find and correct the fault.
2. Read the corresponding section in these instructions carefully.
3. Look on the Internet at www.vivanco.com to see whether the fault and its correction
are described.
4. Ask your dealer.
5. Call the telephone hotline 01805 / 40 49 10 ( 0.12/min.) for Germany. You will find
contacts for Europe at www.vivanco.com
10
GB
3
863 - 865 MHz
FM
Transmitter: AC adapter 12 Volt/ 200mA
RF headphone: 2x micro AAA batteries
max. 10 mW
5 - 40° C
Problem Possible cause
No transmission / no sound Devices are outside range
Batteries are empty
Connection cut off
Incoming signal not loud enough
Interference can be heard during Interference on channel
transmission Batteries are almost empty
Devices are on outer margin of
range
Position of transmitter
Rechargeable batteries are not
No charging charged
Licence
This Vivanco RF product conforms to the European R&TTE directive for RF systems in
harmonised frequency ranges. These systems may be sold and operated in the EU and in
EFTA countries.
Operation is not permitted in any countries not named.
The declaration of conformity is included at the end of this manual.
Warranty
The warranty period is 24 months from the date of purchase.
Hotline
Contact Germany: Telephone hotline 01805 / 404910 (0.12
or http://www.vivanco.de.
European contacts can be found at http://www.vivanco.com.
* is a trademark of SRS Labs, Inc
GB
Solution
Reduce distance between devices.
If ordinary batteries are used, replace them.
If you use the supplied batteries, charge them.
Check that all cable connections are correctly made.
Increase the volume of the incoming signal (music, etc.).
Change the channel using the Auto-Tuning function.
The batteries are almost empty and need to be replaced. If you
use the supplied batteries – charge them.
Transmitter and RF headphone are too far apart. Bring the RF
headphone closer to the transmitter.
In some cases it may be necessary to place the transmitter
somewhere else or higher.
Check that the headphone is correctly positioned in the charging
tray. The charging indicator lights up red when charging is in
progress.
/ min.)
11