Smarter tools MIG-135 Manual Del Operador página 45

A) Amp Adjustment Switches
The Amp Adjustment Switches allow for adjustment between four
different amp settings.
Switch Settings
MAX-2
MAX-1
MIN-2
MIN-1
B) Over Heat Indicator
The welding power source is protected by a self resetting thermostat.
The indicator will illuminate if the duty cycle of the power source has
been exceeded. If the Over Heat light illuminates wait for the Over Heat
light to extinguish before resuming welding.
C) Wire Feed Control
The wire feed speed is increased by turning the Wire Feed Control knob
clockwise or decreased by turning the Wire Feed Control knob
counterclockwise. The wire feed speed should be set according to the
specific application. Refer to the wire manufacture's literature for further
information.
D) Power Switch
The Power Switch turns on and off the power supply to the welding
power source.
Welding Current in Volts
34V
28V
24V
21V
4-2