AEG SB2E 850 RS Instrucciones De Uso página 5

Three jaw chuck
(according to
standard
equipment)
Changing the
three jaw chuck
Inserting tools
Direct reception
of screwdriver
bits
Positioning the
auxiliary handle
ENGLISH
Due to the high power potential of the
percussion drill the chuck might get stuck
at very high load and can not be opened
by hand.
In this case, please steady the chuck head
with a fork wrench and loosen the front
sleeve of the chuck with aid of a footprint
anti–clockwise (see illustration). The use
of a footprint will not cause any damage to
the chuck.
Always disconnect the plug from the socket before carrying out any work on the
machine.
1.
Hold the drive shank with the open-jaw
spanner.
2.
Insert the drill chuck key in the drill chuck
and loosen the drill chuck to the left by
tapping it lightly with a rubber hammer.
3.
Mount the chuck in reverse order.
The chuck can be used for drill bits or
screwdriver bits. For this purpose, open
the chuck, insert the selected bit and
secure by tightening the chuck with the
chuck key.
To remove tools insert chuck key into one
of the three holes at the chuck mouth and
turn anti- clockwise.
Screwdriver bits can be inserted directly
into the working spindle. This results in
the following advantages:
Screwdriver bits can be exchanged easier
and quicker.
Better view at the screw fitting.
The weight of the machine is reduced
when not working with the chuck.
The auxiliary handle can be positioned as
required. Loosen the clamping by twisting
the auxiliary handle, bring the auxiliary
handle into the required position and
re–fasten the handle.
4
SB2E 850 RS, SB2E 1010 RS, SB2E 1200 RST
1
1