Clatronic DB 2732 Instrucciones De Servicio página 32

5....-05-DB 2732
GB
• Clean the ironing base with a slightly damp cloth.
• Fill the water tank through the filler aperture with pure water (up to degree of
hardness 2). If the tap water is harder please use distilled water. Please use a
filling container.
NOTE: Only clothes should to be ironed with this machine.
Ironing without Steam (
1. Place the iron on its stand
2. Electrical connection
Make sure that the iron voltage (see name plate) and the line voltage match.
3. Sort out the garments according to their ironing temperatures. Start with the
lower temperatures. It is set with the thermostat (1):
• Synthetics, silk
• • Wool
• • • Cotton, linen
4. Only connect the machine to a properly installed safety socket, 230 V/50 Hz.
5. The control lamp (2) lights up. As soon as it shuts off, the set temperature is
reached. Now you can start to iron.
6. Always pull the plug out of the socket after using the iron.
Steam Ironing (
For this a high temperature is needed (cotton, linen). The quantity of steam can be
regulated using the steam quantity regulator (5). Extra steam can be added with the
steam jet function (4).
When ironing at low temperatures please ensure that you reduce the amount of
steam.
Vertical Steam
This can be used to produce a jet of steam in a vertical direction.
Self-Cleaning (Self-Clean
1. Half fill the water tank with water.
2. Heat the machine up to its maximum temperature. After the control lamp goes
off remove the machine from the mains supply.
3. Now hold the machine horizontally above a sink, turn the steam quantity control
(5) to the self-cleaning symbol and rock it to and fro until the tank is empty.
Then turn the control back to "0".
4. Place the machine back on its stand and heat it up again. To clean the base
now iron over a clean cotton cloth.
32
06.11.2002 10:22 Uhr
First Use of the Machine
Using the Machine
)
(low temperature)
(medium temperature)
(high temperature)
)
)
Seite 32