Troubleshooting - Makita UB0800 Manual De Instrucciones Original

CLEANING THE COLLECTION BAG
• Empty the collection bag after each use to avoid dete-
rioration and obstruction of the air low which will reduce
the performance of the unit.
• Clean the collection bag as needed. With eye protection
on, turn the dust bag inside out after initial emptying and
vigorously shake out the dust and debris.
DISPOSAL
Waste electrical products should not
be disposed of together with household
waste. Please recycle where facilities
exist. Check with your local authority or
retailer for recycling advice.
TROUBLE SHOOTING
PROBLEM
Unit will not blow or
mulch.
Unit will not start.
10
POSSIBLE CAUSE
1. Bag full
. Blocked tube
3. Blocked impeller
4. Dirty bag
5. Torn bag
6. Bag unzipped
7. Unit unplugged
1. Unit is unplugged.
. Power/speed slide switch is in
the OFF position.
3. Mulcher tubes and bag, are not
correctly installed.
4. Intake gate/cover is not closed.
5. House circuit may have tripped.
MAINTENANCE AND STORAGE INFORMATION
Prior to cleaning or any maintenance, always ensure the
power plug has been removed from the electric power
supply. When you have inished using the tool, always
check to make sure the product is clean and free of dirt
and debris.
• Do not use solvents to clean the tool.
• Store the tool in a dry place, and out of reach of
children.
POWER CORD MAINTENANCE
If the supply cord needs replacing, the task must be car-
ried out by an authorised service centre in order to avoid
a safety hazard.
If the supply cord is damaged, it must be replaced by
Makita service center in order to avoid a hazard.
SOLUTION
1. Empty the bag.
. Clear the blockage.
3. Clear the blockage.
4. Clean the bag.
5. Replace the bag.
6. Zip up the bag.
7. Plug into an outlet or an extension cord.
1. Check cord to make sure it is plugged into an
electrical outlet.
. Slide switch to high or low.
3. Check the mulcher tubes and bag to ensure
that they are allowing the switch to be
engaged when correctly installed.
4. Ensure that gate/cover is fully closed and
locked.
5. Check wall circuit breaker panel and reset if
necessary.