Troubleshooting - Makita XBU02 Manual De Instrucciones

Check item / Operating
time
Oil tank Check
cap tightness.
Chain catcher Inspection.
Screws Inspection.
and nuts

TROUBLESHOOTING

always using Makita replacement parts for repairs.
Malfunction status
little use.
No oil on the chain.
maximum RPM.
in green.
Chain does not stop even the
chain brake is activated:
Stop the machine
immediately!
Abnormal vibration:
Stop the machine
immediately!
Before Everyday
operation
-
- -
- -
Battery cartridge is not installed. Install a charged battery
Battery problem (low voltage).
Main power switch is off.
Chain brake activated.
Battery's charge level is low.
Oil tank is empty.
Oil guide groove is dirty.
Poor oil delivery.
Battery cartridge is installed
improperly.
Battery power is dropping.
correctly.
Switch trigger is pulled under an
unoperatable condition.
Loose guide bar or saw chain.
Every Every 3
week month
-
Cause
22
ENGLISH
Annually
- -
- -
- -
Action
cartridge.
Recharge the battery cartridges.
If recharging is not effective,
replace the battery cartridge.
turned off if it is un-operated for
main power switch again.
Release chain brake.
Recharge the battery cartridges.
If recharging is not effective,
replace the battery cartridge.
Fill the oil tank.
Clean the groove.
Adjust the amount of oil delivery
with the adjusting screw.
Install the battery cartridges as
described in this manual.
Recharge the battery cartridge.
If recharging is not effective,
replace the battery cartridge.
ter in your region for repair.
Pull the switch trigger after the
main power switch is turned on
and the chain brake is released.
ter in your region for repair.
Adjust the guide bar and saw
chain tension.
ter in your region for repair.
Before
storage
-
-
-
-
-
-